MMAC 100 / MMHC 105 Series Cylinders
Chrysler Heavy Duty Steel Cylinders, Pneumatic 200 PSI / Hydraulic 1000 PSI pressure rating. NPTF ports standard, NFPA interchangeable dimensions. 1 1/2" to 8" bores, (5) mount styles available. Dimensionally interchangeable with Chrysler standards.
General Specifications
- The bearing retainer is held in place by cap screws and the bearing cartridge assembly is easily removed without disturbing the tie rods on all mounts except the rod end flange.
- The bearing cartridge is extra long for high cycle usage in automation equipment. This bearing is close tolerance machined from 660 bearing bronze, fitted with self compensating rod wiper, rod packings and bearing O-ring. Bearing wick to insure even distribution of lubricant.
- All male rod threads have four wrench flats furnished as standard
- The piston rods are 100,000 PSI minimum tensile steel, ground, polished and hard chrome plated to a 15 RMS finish or better.
- Cushion adjustment screws and ball checks are both interchangeable and flush to the head and cap
- Cushions for deceleration are supplied as an option and do not change mounting or overall dimension of the cylinder
- Piston wear band: Delrin band insures no metal-to-metal contact.
- Piston is one piece fine grained grey iron machined with long thread engagement with the piston rod to provide better shock absorption. The piston is longer than the average cylinder to provide additional bearing surface for long life.
- Heads and caps are cold rolled steel machined to provide concentricity for mating components.
- Cylinder tube is 1015 through 1020 steel honed and hard chrome plated on the ID to a 15 micro inch finish or better.
- The piston cups are self compensating dynamic seals of Buna N that adjust for pressure variations and wear. Other compounds can be supplied for an additional charge.
- O-rings are used for static seals at the tube, bearing, ball check, cushion adjustment and rod end cushion.
- N.P.T.F. ports are standard for both air and hydraulic usage. SAE O-ring ports can be supplied for hydraulic application at no additional charge.
- Tie rods are made from 100,000 PSI minimum tensile steel.
- * NO ADDITIONAL LUBRICATION NEEDED (NON-LUBE SERVICE)
Catalog
Our MMAC 100 / MMHC 105 Catalog is available as a PDF File. You will need Adobe Reader to view this file.
